Sanyo PLC-WXU700A Manual Do Utilizador

The preparation display will disappear 

after 30 seconds.

(See page 58 for Lamp control status.)

Connect the projector’s AC power cord into an AC 

outlet. The POWER indicator lights red. Open the lens 

cap (see pages 9, 66).
Press the ON/SYAND-BY button on the top control or 

on the remote control. The POWER indicator lights 

green and the cooling fans start to operate. The 

preparation display appears on the screen and the 

count down starts. 

After the countdown, the input source that was selected 

the last time and the lamp control status icon (see page 

58) appear on the screen.

Complete peripheral connections (with a computer, 

VCR, etc.) before turning on the projector.  



    The Filter warning and Lamp replacement icons 

may appear on the screen depending on the 

usage state of the projector.

Lamp control status



  • When the Logo select function is set to 

Off, the logo will 

not be shown on the screen (p.50).

  • When 

Countdown off or Off is selected in the Display 

function, the countdown will not be shown on the screen 

(p.49).

  • When the Input Search function is set to 

On, the input 

signal will be searched automatically (p.48).

 •  When 

Off is selected in the Display function, the Video/

PC selection window and the input signal guidance 

window are not shown on the screen (p.49).

If there is no signal input when start on the projector,

or the current signal is missed while operating the

projector, the Video/PC selection window will be

displayed on the screen, please move the pointer to

input source desired by pressing the Point ▲▼ buttons

and press the SELECT button. And then follow the

input signal guidance window to correct the signal and

connection.

If the projector is locked with a PIN code, PIN code input 

dialog box will appear. Enter the PIN code as instructed 

on the next page.

No signal

Current Input setting       Video 

VIDEO

S-VIDEO

Is signal processed correctly?  
Is cable connected properly?  

No signal

Current Input setting   COMPUTER1 RGB

Is signal processed correctly?  

Is cable connected properly?