Sanyo PLV-Z4 Manual Do Proprietário

Select L1 or L2 with the Point 

8

or OK buttons according to the

output signal of video equipment.  

L1  . . . . . When the output of video equipment is set

“STANDARD”.

L2  . . . . . When the output of video equipment is set

“ENHANCED”.

The names for the output setting of video equipment vary from
equipment to equipment. For details, refer to the owner’s manual
of video equipment.

Mounting
This function is used to select the installation methods of the
projector. Press the Point 

8

or OK buttons to switch between

each mode.

Off  . . . . . Cancel the selected installation method.
Ceiling  . . Project the image from the ceiling-mounted

projector. The picture is top/bottom and left/right
reversed. 

Wall  . . . . Project the image from a wall-hanging projector. The

picture is left/right reversed.

Rear
When this function is “On,” the picture is left/right reversed. This
function is used to project the image to a rear projection screen.
Press the Point 

8

or OK buttons to switch On/Off.

Blue back
When this function is “On”, the projector produces a blue image
while an input signal is not detected. Press the Point 

8

or OK

buttons to switch On/Off.

This function decides whether to display the On-Screen Displays.
Press the Point 

8

or OK buttons to switch between each mode.

On  . . . . . . . . . . . . Show all the On-Screen Displays. Use this

function when you want to project images
after the lamp becomes bright enough. The
factory default setting is this mode.

Countdown Off  . . Show the input image instead of the

countdown when turning on the projector.
Use this function when you want to project
the image as early as possible even when
the lamp is not bright enough.

Off . . . . . . . . . . . . Hide the On-Screen Displays except;

● On-Screen Menu
● “Power off?”
● “No signal” for Power management (p.37)
● “Please wait ...”
● Color management operation screen
● Panning dialog box when Normal through

is selected in the Screen Menu (p.34).

Press the Point 

8 or OK

buttons to select L1 or L2
according to the output
signal of video equipment.