TallyGenicom 2365 Guia Do Utilizador

If the printer detects an internal fault or user error or if it expects you 
to do something, a message will appear in the LC display. It also dis-
plays the status during an operation (e.g. Initializing). Below you 
will find a list of messages with brief descriptions of each message. 
The messages are described in greater detail in the chapter 

. 

Eject error

The printer cannot eject the paper/
advance it to park position.

Hardware Alarm

Internal hardware error. Try power 
cycling the printer. If the message 
appears again, contact your dealer or 
service technician.

Initializing

This message appears during the 
printer’s initializing phase after switch-
ing on the printer.

Load error

The printer cannot draw in the loaded 
paper.

Load paper from

The printer has detected paper end 
during operation/printer was switched 
on with no paper loaded.

Loading default

Factory defined parameters will be 
reloaded in all available menus after 
switching on the printer.

Out of paper

The printer has detected paper end 
during operation / printer was switched 
on with no paper loaded.

Paperwidth error

Print characters override the detected 
right paper margin.

Parity error

A parity error during data transmission 
is indicated.

Park position

Paper is not being fed into print posi-
tion.

Press any key

The user is requested to press any 
key.

PW sensor defect

The automatic paper width detection 
cannot detect the left paper margin.

Selftest

After power-on, the printer executes a 
short hardware self-test.