GE js998skss Instrução De Instalação

• Locate the centers of the 4 holes identified

in the illustration at left as FLOOR–WOOD
and Wall.

• Drill a 1/8

″ pilot hole through the 

pre-marked areas. Note the angle of the
wall screw in the illustration below.

• Mount the Anti-Tip bracket with the 

4 screws provided.

• For concrete installation, you will need two

1/4

″ x 1-1/2″ lag screws and two sleeve

anchors.

• Locate the center of the 4 holes identified in

the illustration at left as FLOOR–CONCRETE
and Wall. Drill the recommended size holes
in each.

• Install the sleeve anchors into the predrilled

concrete holes and install the lag and wall
screws through the Anti-Tip bracket. Make
sure the screws are securely tightened.

• Decide whether the bracket will be installed

on the right or left side of the range opening.

• Place the bracket as shown below.

Attach the Anti-Tip bracket per above, making
sure that the rear of the bracket is 25

″ from

the front of the countertop.

Be aware that the screws provided are long
and may penetrate through the back of the
island cabinets. In this event, use shorter
screws (not provided) or the screws provided
should be used in the floor.

Do not use the Backguard Kit with this 
type of installation. Use Maintop Filler Kit
(supplied with this range) if required, and
install using Alternate Construction section.

To Front Edge

of Countertop

Screw

Must Enter

Wood 

or Metal

Bracket

Wall Plate

25

″

FLOOR–CONCRETE

Rear 
Leveling Leg

Adjacent Cabinet

Wall

FLOOR–WOOD

Bracket Side

Replace the wire cover 
(on the back of the range)
by replacing the 2 screws
removed earlier.

Wire
cover