Adtran 3458-poe Guia De Configuração Rápida

Quick Start Guide, 61200824G1-13A, March 2009

1

4

Copyright © 2009 ADTRAN, Inc. All Rights Reserved.

Two configuration methods are available for your NetVanta router:

•

Web-based graphical user interface (GUI)

•

AOS command line interface (CLI)

The GUI lets you configure the main unit settings and provides online guidance and explanations 
for each setting. However, using the AOS CLI may be necessary for more advanced 
configurations. 

You may access the GUI from any Web browser on your network by following these steps:

1.

Connect the router to your PC using the ETH 0/1 port on the back of the unit.

2.

Set your PC to a fixed IP address of 10.10.10.2. If you cannot change the PC’s IP address, 
you will need to change the unit’s IP address using the CLI. (Refer to the next two sections 
for instructions.)

3.

Enter the unit’s IP address in your browser address line. The default IP address is 
10.10.10.1.

4.

You will then be prompted for the user name and password (the default settings are admin 
and password).

5.

The initial GUI screen appears.

Access the AOS CLI via the CONSOLE port or a Telnet session. To establish a connection to the 
NetVanta router CONSOLE port, you need the following items:

•

VT100 terminal or PC (with VT100 terminal emulation software)

•

Straight-through serial cable with a DB-9 (male) connector on one end and the appropriate 
interface for your terminal or PC communication port on the other end

1.

Connect the DB-9 (male) connector of your serial cable to the CONSOLE port on the front 
panel of the unit.

2.

Connect the other end of the serial cable to the terminal or PC.

3.

Provide power to the unit as appropriate. Refer to the NetVanta 3000 Series Hardware 
Installation Guide (provided on the AOS Documentation CD) for more details.

4.

Once the unit is powered up, open a VT100 terminal session using the following settings: 
9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press <Enter> to activate the 
AOS CLI.

5.

Enter enable at the > prompt.

6.

Enter the enable password when prompted. The default password is password.

More detailed documentation for configuring your ADTRAN unit is provided on the AOS 
Documentation CD included in your shipment. For more detail on hardware setup, refer to the 
appropriate NIM quick start guides and the hardware installation guide. For more detail on 
configuring your system, refer to the AOS Command Reference Guide, configuration guides, and 
technical support notes.