Mitsubishi wd-52628 Manual Do Utilizador

The Record menu allows you to set up recordings, view 

the record list, and set defaults for your recording 
devices.

The recording Setup screen is where you tell the TV what, 

where, and when to record.  There are two ways to open 
the Recording Setup screen:

•  select Record from the Record menu.
•  press REC on the remote control when viewing a 

recordable source.

Your TV can stop recordings automatically and it can 

send the signals from one external playback device 
to another external recording device.  It is also able to 
convert digital channels and IEEE 1394 device signals to 
analog signals.  These converted signals can be recorded 
on NetCommand-compatible analog VHS and S-VHS 

VCRs connected to the RECORD OUTPUT/VIDEO and 
AUDIO outputs on the back of the TV.

You can schedule the recording to take place at a later 

time and program the recording duration for a minimum 
of 30 minutes and a maximum of six hours (in 30-minute 
increments).  The default is one hour.

When a digital recording is being made, the TV can direct 
the signals to the recording device using the IEEE 1394 
cable.  In the case of an analog recording, (as to a VCR) 
the TV converts the digital signals to analog format and 
sends the analog output to the VCR through the RECORD 
OUTPUT jacks.

During the recording, you can view a different device or 
power off the TV.  See Appendix I for more information.

To prevent recording of unwanted material while 

recording to a VCR or A/V disc, press PAUSE to 
temporarily stop recording.  Press PAUSE again to 
resume recording.

Can be used when viewing Antenna 1 or 2, an IEEE 1394 
device, or a non-recording traditional device. 

To initiate recording now:
1.  Press REC (record) on the TV remote or press 

ENTER if the Record menu is displayed.

2.  Review the Record To (destination) device (VCR) and 

duration.  Change if necessary.

3.  Press REC a second time to initiate recording.

To initiate a time-delayed recording:
1.  Set the TV to the source you want to record.

2.  Press REC (record) on the TV remote or press 

ENTER if the Record menu is displayed.

3.  Press ADJUST   or   to select the channel, device 

to record to, duration time, start time (press ENTER 
after selecting hour and minutes to set the time) and 
day.

4.  Select Add and press ENTER to add the recording 

to the record list.  If your selection is successful, a 
confirmation message will be displayed.  If you pick 
overlapping times, day(s), or destination devices, 
you will see a message stating there is a conflict.

5.  To exit, press HOME on the TV remote after all 

recordings have been added.

You cannot record from an analog channel or device or a 

VHS or S-VHS VCR to a digital recording device such as 

a DVCR or A/V Disc.