Quantum SuperLoader 3 Guia De Configuração Rápida

Unpacking the Autoloader

Unpacking the Autoloader

Before you begin, clear a desk or table so that you can unpack the autoloader.
The Quantum SuperLoader 3 Quick Start Guide

 

has all the necessary information to unpack 

and inspect your autoloader correctly. 
You also need to select an open 2U computer rack location near the server that will host 

the autoloader.

Carefully unpack and inspect your new Quantum SuperLoader 3 by doing the following:

Inspect the shipping box for damage. If you notice any damage, report it to the 

shipping company immediately.

Open the shipping box and remove the accessories package. Set the accessories 

package aside for now.

Lift the autoloader and padding out of the box and place it on the work surface, top 

facing up. Do not set the autoloader on either end or sides.

Carefully remove the shipping padding from the left and right sides of the 

autoloader. Then remove the bag from the autoloader.

Remove the foam insert from the magazine bay of the autoloader. Save the packing 

materials in case you need to move or ship the autoloader in the future.

Do not remove the top cover of the autoloader during the installation 

process. Removing the top cover could result in damage to the 

autoloader.

If the room in which you are working differs from the temperature in 

which the autoloader was shipped or stored by 15° C (30° F) or more, let 

the autoloader acclimate to the surrounding environment for at least 12 

hours before removing it from the shipping carton.

If your unit was ordered as a one-magazine autoloader, be sure to remove 

the plastic shipping insert from the magazine bay before connecting or 

operating your autoloader. Insert either a magazine or a magazine blank 

into the bay. The autoloader will not function without both magazine bays 

equipped with either a magazine or a magazine blank.

If the cover must be taken off, there are 26 screws that need to be removed.