Roland g-70 Manual Do Proprietário
Using the individual outputs and audio inputs
G-70 Music Workstation
r
103
Using the individual outputs and
audio inputs
audio inputs
Output assign (PART OUTPUTS)
The G-70 is equipped with four outputs grouped into
two pairs: MAIN and DIRECT.
two pairs: MAIN and DIRECT.
By default, all parts are assigned to the MAIN sockets.
When using the G-70 for multitrack recording or if a
given part should be processed using an external
effects device, you may want to take advantage of the
DIRECT sockets.
When using the G-70 for multitrack recording or if a
given part should be processed using an external
effects device, you may want to take advantage of the
DIRECT sockets.
Parts assigned to the DIRECT sockets are not processed
by the G-70’s effects, nor controlled by the
[MASTER¥VOLUME] knob on the front panel.
by the G-70’s effects, nor controlled by the
[MASTER¥VOLUME] knob on the front panel.
Except for the Vocal Harmonist and Audio In signals, all
of the G-70’s parts can be freely assigned to the desired
OUTPUT sockets.
of the G-70’s parts can be freely assigned to the desired
OUTPUT sockets.
Here is how to assign a part to the desired output:
(1) Press the [EFFECTS] button.
(2) Press the PART OUTPUTS [EDIT] field.
(3) First decide which group contains the part whose
assignment you want to change, then press the
corresponding PART SELECT field.
corresponding PART SELECT field.
The display changes accordingly. Though the part
names vary, the basic behavior is the same for all
three pages. For this example, we’ll use the page that
contains the Style parts (activate the [STYLE] field):
names vary, the basic behavior is the same for all
three pages. For this example, we’ll use the page that
contains the Style parts (activate the [STYLE] field):
(4) Press the [MAIN] or [DIRECT] field of a part to assign
it to the corresponding output pair.
“MAIN” refers to the main outputs (which are stereo)
and “DIRECT” to the sockets of the same name (which
are also stereo).
“MAIN” refers to the main outputs (which are stereo)
and “DIRECT” to the sockets of the same name (which
are also stereo).
To send only one signal to each of the DIRECT out-
puts, you also need to change the following.
puts, you also need to change the following.
Note: The Harmonic Bar signals cannot be assigned to the
DIRECT outputs.
DIRECT outputs.
• Press the [PART] button.
• Press the [PAN¥POT÷VOLUME] button to assign the
PANPOT parameter to the sliders.
The display changes to:
The display changes to:
• Use the 9 sliders below the display to change the ste-
reo placement of the available parts.
KBD: The Keyboard parts, D Beam and Melody Intel-
ligence part.
STYLE: The Style parts (Arranger).
SONG: The Song parts (Recorder).
OUTPUT
DIRECT
MAIN
R
L
R
L / MONO
Pan for Keyboard parts
PART