Roland g-70 业主指南

G-70 Music Workstation 

r

The G-70 is equipped with four outputs grouped into 
two pairs: MAIN and DIRECT.

By default, all parts are assigned to the MAIN sockets. 
When using the G-70 for multitrack recording or if a 
given part should be processed using an external 
effects device, you may want to take advantage of the 
DIRECT sockets.

Parts assigned to the DIRECT sockets are not processed 
by the G-70’s effects, nor controlled by the 
[MASTER¥VOLUME] knob on the front panel.

Except for the Vocal Harmonist and Audio In signals, all 
of the G-70’s parts can be freely assigned to the desired 
OUTPUT sockets. 

Here is how to assign a part to the desired output:

(1) Press the [EFFECTS] button.

(2) Press the PART OUTPUTS [EDIT] field.

(3) First decide which group contains the part whose 

assignment you want to change, then press the 
corresponding PART SELECT field.

The display changes accordingly. Though the part 
names vary, the basic behavior is the same for all 
three pages. For this example, we’ll use the page that 
contains the Style parts (activate the [STYLE] field):

(4) Press the [MAIN] or [DIRECT] field of a part to assign 

it to the corresponding output pair.
“MAIN” refers to the main outputs (which are stereo) 
and “DIRECT” to the sockets of the same name (which 
are also stereo).

To send only one signal to each of the DIRECT out-
puts, you also need to change the following.

Note: The Harmonic Bar signals cannot be assigned to the 
DIRECT outputs.

• Press the [PART] button.

• Press the [PAN¥POT÷VOLUME] button to assign the 

PANPOT parameter to the sliders. 
The display changes to:

• Use the 9 sliders below the display to change the ste-

reo placement of the available parts.

KBD: The Keyboard parts, D Beam and Melody Intel-

ligence part.

STYLE: The Style parts (Arranger).

SONG: The Song parts (Recorder).