Yamaha RX-V4600 Manual Do Proprietário

■ Assigning i.LINK components

When an i.LINK component is connected, this unit 
automatically recognizes the connection and registers up 
to 16 i.LINK components. Assigning an i.LINK 
component to a specific input allows you to select video 
and audio input signals from that component received via 
the i.LINK connection for simultaneous playback.

Turn on the power of this unit and the connected 
i.LINK component.
The i.LINK component is automatically recognized and 
registered in the following order:
DVD 

→ DTV → CBL/SAT → VCR1 → DVR/VCR2 → 

V-AUX 

→ PHONO → CD → CD-R → MD/TAPE

“LINK CHECK” flashes on the front panel display during 
this procedure.

• If you want to change the input assignment of a registered 

i.LINK component, use Input Assign in the GUI menu 
(see page 93) or INPUT ASSIGN in the front panel display 
system options menu (see page 90).

• Only one i.LINK component is assigned to each input and 

inputs that are already assigned are skipped.

• If i.LINK components are assigned to all the inputs available, 

no more i.LINK components can be assigned, and audio signals 
input from these i.LINK components cannot be played back on 
this unit.

■ Listening to playback from i.LINK 

If an i.LINK component has been assigned to a specific 
input, perform the following steps to listen to playback 
from the registered i.LINK component.

• You can turn on/off automatic playback when an i.LINK 

component is selected using the INPUT selector or to select 
whether you want the input to switch automatically when an 
input stream from a connected i.LINK component is detected 
(see page 93).

• Audio signals input at the i.LINK jacks are digitally output only 

when AUDIO SELECT is set to either AUTO or i.LINK as the 
input mode and REC OUT/ZONE 2 on the front panel is set to 
SOURCE/REMOTE.

Use this menu to display information about registered 
i.LINK components, delete any unused registered 
components, or customize the operation and playback 
settings to be used when this unit is connected to an 
i.LINK component.

Set AMP/SOURCE/TV to AMP, then press 
TOP on the remote control.
The top display appears.

Press k / n repeatedly to select i.LINK Select.

Press ENTER or h, then press k / n 
repeatedly to change the setting of the item 
you want to adjust.

A.SEL:AUTO

A.SEL:i.LINK