Yamaha RX-V4600 Manual Do Proprietário
94
USING i.LINK
■ Status display messages
The following messages may appear on the front panel display depending on the status of this unit.
The following messages may appear on the front panel display depending on the status of this unit.
*
Playback may stop while this message is displayed.
■ Error messages
The following messages appear on the front panel display if a connection or registration error is detected.
The following messages appear on the front panel display if a connection or registration error is detected.
■ i.LINK indicator
i.LINK display messages
Message
Contents
LINK CHECK
Flashes while the i.LINK component connection is being checked.
*
Message
Cause
Remedy
BUS FULL
The 1394 bus transmission band is full, and no
more data can be transmitted.
more data can be transmitted.
This problem may be resolved by disconnecting any
unused i.LINK components.
unused i.LINK components.
If an i.LINK component with a slow transmission speed
(S100 or S200) is connected between this unit and the
i.LINK (AUDIO) component which you want to play
back, the bus may become full. Changing the
connection order of the i.LINK components so that this
unit and the i.LINK (AUDIO) component are directly
connected may resolve this problem.
(S100 or S200) is connected between this unit and the
i.LINK (AUDIO) component which you want to play
back, the bus may become full. Changing the
connection order of the i.LINK components so that this
unit and the i.LINK (AUDIO) component are directly
connected may resolve this problem.
CANNOT LINK
The connected i.LINK component is not
recognized because the connection is
incomplete.
recognized because the connection is
incomplete.
Check that all i.LINK components are connected
properly using an IEEE1394 cable.
properly using an IEEE1394 cable.
LOOP CONNECT
This unit and the i.LINK component are
connected in a loop (where the output signal is
returned to the original component).
connected in a loop (where the output signal is
returned to the original component).
Disconnect the IEEE1394 cable, then reconnect it in
either a daisy chain or tree configuration.
either a daisy chain or tree configuration.
NODE OVER
More than 63 i.LINK components (including
this unit) are connected.
this unit) are connected.
Reduce the number of connected components.
HOP OVER
More than 15 i.LINK components are
connected in a daisy chain configuration.
connected in a daisy chain configuration.
Reduce the number of i.LINK components connected
between the two end components to 15 or less.
between the two end components to 15 or less.
Reconnect the i.LINK components using tree-type
connections.
connections.
REGIST. OVER
A new i.LINK component is connected to this
unit while 16 i.LINK components are already
registered. This unit can register up to 16
i.LINK components.
unit while 16 i.LINK components are already
registered. This unit can register up to 16
i.LINK components.
Delete any unused registered i.LINK components from
the registered components list and reconnect the
i.LINK component you want to register.
See “Changing i.LINK Select parameters” on page 92.
the registered components list and reconnect the
i.LINK component you want to register.
See “Changing i.LINK Select parameters” on page 92.
Lights up
When an i.LINK component is connected, and this unit is playing back signals input via
i.LINK connections.
i.LINK connections.
Flashes
When an i.LINK component is connected, but this unit is playing back signals input via
connections other than i.LINK or no signals are being input via i.LINK connections.
connections other than i.LINK or no signals are being input via i.LINK connections.
Off
When no i.LINK component is connected.