Zhone 1813 Guia Do Utilizador

RIP is a protocol that automatically updates the routing entries on the system. This is done by 
cooperating with other nearby routers. The RIP commands are located in the “rip” directory. 
Two commands are available: rip and ver. In order for any configuration changes to take effect, 
the configuration must be saved (with “save” command) and the system rebooted.  

 

Rip starts and stops automated updates of routing tables. When RIP is enabled, the system 
communicates with other routers in the network to update and maintain the IP routing tables. By 
default, RIP is not enabled. If RIP is enabled but no version is specified, RIP version 1 is used. 
This command is available in the “rip” directory. 

To enable RIP, type the following command with ON capitalized. 

 

A change success message displays. 

To disable the RIP function, use the following command with OFF capitalized. 

 

This command specifies the version of the RIP protocol that will be used. The permissible values 
are 1 or 2. The default is 1. 

 

This command lists the routes currently available. 

101