Zhone 1813 Guia Do Utilizador
Command Line Interface User’s Guide
5.15 SNDCP
The SNDCP commands are located in the sndcp directory.
routedbridge
ipoa
list
pppoe
pppoealive
onetime
pppoestart
pppoestop
pppoelist
pppoedefault
pppoa
pppoedel
pppoadel
pppoastart
pppoastop
pppoalist
pppoadefault
liststat
ppptrace
mss
1483mer
mer
relay
5.15.1
pppoe
pppoe <profile> -o <-if Interface> <-encap Encapsulation> <-restarttime Timeout> <-auth
Auth> <-myaddr IPAddr> <-peer PeerIPAddr> <-mtu MTU> <-mru MRU> <-hwaddr
Ethaddr> <-service ServiceName> <-acname ACName> <-tag HostTag> <-user Username>
<-pass Password> <-vpi Vpi> <-vci Vci> <-mode Mode> <-idletime idleTimeout> <-nat
[enable/disable]> <-netmask mask> <-vpn OUI vpnId>
Auth> <-myaddr IPAddr> <-peer PeerIPAddr> <-mtu MTU> <-mru MRU> <-hwaddr
Ethaddr> <-service ServiceName> <-acname ACName> <-tag HostTag> <-user Username>
<-pass Password> <-vpi Vpi> <-vci Vci> <-mode Mode> <-idletime idleTimeout> <-nat
[enable/disable]> <-netmask mask> <-vpn OUI vpnId>
This command sets up a PPPoE profile. A PPPoE entry can be added by using the simplified
command as follows. Other part of the command is optional.
command as follows. Other part of the command is optional.
pppoe <profile> -o -if <interface> -user <user> -pass <password> -vpi <vpi> -vci <vci>
102 1800-A2-GB20-00