Zhone 1813 Guia Do Utilizador

Vpi 

The ATM vpi value which was assigned in a vcadd command or listed in a atmshowconn 
command. 

Vci 

The ATM vci value which was assigned in a vcadd command or listed in a atmshowconn 
command. 

mask 

This specifies the netmask for the PPP interface. The mask is specified in dot notation 
(i.e.255.255.255.0). 

Mode 

Mode can be AUTO or DIRECT. In case of mode being set to AUTO the PPPoE negotiation 
starts only when the system identifies any traffic required to be transferred on the link and in 
case of DIRECT the PPPoE negotiation is started manually using “pppoestart” command. The 
default is DIRECT. 

idleTimeout 

The value of idletime is given in minutes and this value indicates how long the link remains up 
when there is no data transfer over the link. The idle time works only when used in combination 
with mode AUTO. The default is 60 seconds. 

enable|disable 

This enables or disables NAT (Network Address Translation) for this PPP interface. The default 
is for NAT to be disabled. 

mask 

This specifies the netmask for the PPP interface. The mask is specified in dot notation 
(i.e.255.255.255.0). 

OUI vpnId 

This specifies the VPN encapsulation. The OUI (Organizationally Unique Identifier) and VPN 
identifier are specified as numbers. 

 

EXAMPLE 

This command defines a PPPoE profile. The ppp0 interface is used with the ATM connection vpi 
0 and vci 100. The user name is “jones” and the password is “Indiana”.