ZyXEL xgs-4528f Guia Do Utilizador

 Chapter 13 Spanning Tree Protocol

XGS-4528F User’s Guide

Click Advanced Application > Spanning Tree Protocol in the navigation panel 
to display the status screen as shown next. See 

 for 

more information on MRSTP. 

Note: This screen is only available after you activate MRSTP on the Switch. 

Figure 73   Advanced Application > Spanning Tree Protocol > Status: MRSTP 

The following table describes the labels in this screen.  

Tree

Select which STP tree configuration this port should participate in.

Apply

Click Apply to save your changes to the Switch’s run-time memory. The 
Switch loses these changes if it is turned off or loses power, so use the 
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

Table 32   Advanced Application > Spanning Tree Protocol > MRSTP  (continued)

Table 33   Advanced Application > Spanning Tree Protocol > Status: MRSTP 

Configuration

Click Configuration to specify which STP mode you want to activate. 
Click MRSTP to edit MRSTP settings on the Switch. 

Tree

Select which STP tree configuration you want to view. 

Bridge

Root refers to the base of the spanning tree (the root bridge). Our 
Bridge is this Switch. This Switch may also be the root bridge.

Bridge ID  

This is the unique identifier for this bridge, consisting of bridge priority 
plus MAC address. This ID is the same for Root and Our Bridge if the 
Switch is the root switch.