ZyXEL ES-2024A Guia Do Utilizador

Chapter 30 Cluster Management

ES-2024 Series User’s Guide

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch 

loses these changes if it is turned off or loses power, so use the Save link on the 

top navigation panel to save your changes to the non-volatile memory when you 

are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

Clustering 

Candidate 

The following fields relate to the switches that are potential cluster members.

List

A list of suitable candidates found by auto-discovery is shown here. The 

switches must be directly connected. Directly connected switches that are set to 

be cluster managers will not be visible in the Clustering Candidate list.  

Switches that are not in the same management VLAN group will not be visible in 

the Clustering Candidate list.

Password 

Each cluster member’s password is its web configurator password. Select a 

member in the Clustering Candidate list and then enter its web configurator 

password. If that switch administrator changes the web configurator password 

afterwards, then it cannot be managed from the Cluster Manager. Its Status is 

displayed as Error in the Cluster Management Status screen and a warning 

icon (

) appears in the member summary list below.

If multiple devices have the same password then hold [SHIFT] and click those 

switches to select them. Then enter their common web configurator password.

Add

Click Add to save your changes to the Switch’s run-time memory. The Switch 

loses these changes if it is turned off or loses power, so use the Save link on the 

top navigation panel to save your changes to the non-volatile memory when you 

are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

Refresh

Click Refresh to perform auto-discovery again to list potential cluster members.

The next summary table shows the information for the clustering members configured. 

Index

This is the index number of a cluster member switch.

MacAddr

This is the cluster member switch’s hardware MAC address.

Name

This is the cluster member switch’s System Name.

Model

This is the cluster member switch’s model name. 

Remove

Select this checkbox and then click the Remove button to remove a cluster 

member switch from the cluster.

Cancel

Click Cancel to begin configuring this screen afresh.

Table 93   Management > Clustering Management > Configuration  (continued)