ZyXEL p-2802h-i1 Manual Do Utilizador

 Chapter 3 Internet and Wireless Setup Wizard

P-2802H(W)(L)-I Series User’s Guide

Figure 13   Internet Access Wizard Setup: ISP Parameters

The following table describes the fields in this screen.

4 The next wizard screen varies depending on what mode and encapsulation type you use. 

All screens shown are with routing mode. Configure the fields and click Next to 
continue. See 

 for wireless connection wizard setup 

"

When you use the connection wizard to configure the Internet access using 
PPPoE, the ZyXEL Device is set to get an IP address from the ISP 
automatically. To set up a static WAN IP address with PPPoE, use the 
Network > WAN screen. 

Table 6   Internet Access Wizard Setup: ISP Parameters

Mode

Select Routing (default) from the drop-down list box if your ISP give you one IP 

address only and you want multiple computers to share an Internet account. Select 

Bridge when your ISP provides you more than one IP address and you want the 

connected computers to get individual IP address from ISP’s DHCP server directly. If 

you select Bridge, you cannot use Firewall, QoS, DHCP server and NAT on the 

ZyXEL Device.

Encapsulation

Select the encapsulation type your ISP uses from the Encapsulation drop-down list 

box. This field is available only when you select Routing in the Mode field.
Choices are Ethernet and PPPoE.

Back

Click Back to go back to the previous screen.

Next

Click Next to continue to the next wizard screen. The next wizard screen you see 

depends on what protocol you chose above. 

Exit

Click Exit to close the wizard screen without saving your changes.