ZyXEL p-2602hw-d1a Manual Do Utilizador

P-2602HW(L)-DxA Series Quick Start Guide

4

3 ETHERNET 1~4: Use Ethernet cables to connect computers to this port for initial configuration and/or 

Internet access.

4 PHONE 1-2: Use a telephone cable (and any telephone adaptors provided with your P-2602HW(L)-DxA) to 

connect your telephones to these ports. If you only have one telephone, you should use port 1.

5 POWER: Use the power adaptor provided with your P-2602HW(L)-DxA to connect an appropriate power 

source to this port.

Note: If you are using T-ISDN (UR-2), connect the green wire to a TAE connector before connecting it 

to a telephone wall jack or the telephone splitter's TEL (or PHONE) jack.

6 Push in the POWER button. Look at the lights on either side of the P-2602HW(L)-DxA.
• The POWER light blinks during start-up and is green once the P-2602HW(L)-DxA is ready.
• Each ETHERNET light turns on if the corresponding ETHERNET port is properly connected. 

The lights blink when the P-2602HW(L)-DxA is sending or receiving data through the corre-
sponding ETHERNET port.

• The DSL light stays on if a physical connection with the ISP is established. The INTERNET 

light stays on when Internet access is available.

• The PHONE lights stay on when your SIP account is registered and they blink if the receiver 

is off the hook.

• The WLAN light turns on when the wireless LAN is ready. It blinks when the P-2602HW(L)-

DxA is sending/receiving data through the wireless LAN. 

If the PHONE 1 or PHONE 2 light is on, go to Section 4 to see how to make calls through 
the Internet.

If the INTERNET light comes on but the PHONE lights are off, go to Section 3.3 and use the 
VOIP SETUP wizard.

If the INTERNET light is off but the DSL light is on, go to Section 3.1 and use the 
INTERNET SETUP wizard to configure your Internet access settings.

If the lights are different than described, go to Troubleshooting.