ZyXEL p-2302hw-p1 Manual Do Utilizador

P-2302HW/HWL-P1 Series User’s Guide

Chapter 5 Wireless LAN

101

Figure 48   OTIST: In Progress on the Wireless Device

These screens close when the transfer is complete.

1 If you enable OTIST in a wireless device, you see this screen each time you start the 

utility. Click Yes to search for an OTIST-enabled AP (in other words, the ZyXEL 
Device).

Figure 49   Start OTIST?

2 If an OTIST-enabled wireless device loses its wireless connection for more than ten 

seconds, it will search for an OTIST-enabled AP for up to one minute. (If you manually 
have the wireless device search for an OTIST-enabled AP, there is no timeout; click 
Cancel in the OTIST progress screen to stop the search.)

3 After the wireless device finds an OTIST-enabled AP, you must click Start in the ZyXEL 

Device’s Network > Wireless LAN > OTIST screen or hold in the Reset button on the 
ZyXEL Device for one or two seconds to transfer the settings again.

4 If you change the SSID or the keys on the ZyXEL Devices after using OTIST, you need 

to run OTIST again or enter them manually in the wireless device(s).

5 If you configure OTIST to generate a WPA-PSK key, this key changes each time you run 

OTIST. Therefore, if a new wireless device joins your wireless network, you need to run 
OTIST on the AP and ALL wireless devices again.

Use this screen to change your ZyXEL Device’s MAC filter settings, click Network > 
Wireless LAN > MAC Filter. The screen appears as shown.