ZyXEL p-2302hw-p1 Manual Do Utilizador

P-2302HW/HWL-P1 Series User’s Guide

Chapter 5 Wireless LAN

99

Use this screen to set up and start OTIST on the ZyXEL Device in your wireless network. To 
open this screen, click Network > Wireless LAN > OTIST.

Figure 44   Network > Wireless LAN > OTIST

The following table describes the labels in this screen.

Before you click Start, you should enable OTIST on all the OTIST-enabled devices in the 
wireless network. For most devices, follow these steps.

1 Start the ZyXEL utility

2 Click the Adapter tab.

3 Select the OTIST check box, and enter the same Setup Key as the ZyXEL Device.

4 Click Save.

Table 39   Network > Wireless LAN > OTIST

Setup Key

Type a key (password) 8 ASCII characters long. 

Note: If you change the OTIST setup key in the ZyXEL Device, 

you must change it on the wireless devices too.

Yes!

Select this if you want the ZyXEL Device to automatically generate a pre-
shared key for the wireless network. Before you do this, click Network > 
Wireless LAN > General and set the Security Mode to No Security.

Clear this if you want the ZyXEL Device to use a pre-shared key that you enter. 
Before you do this, click Network > Wireless LAN > General, set the 
Security Mode to WPA-PSK, and enter the Pre-Shared Key.

Start

Click Start to activate OTIST and transfer settings. The process takes three 
minutes to complete.

Note: You must click Start in the ZyXEL Device and in the 

wireless device(s) within three minutes of each other. You 
can start OTIST in the wireless devices and the ZyXEL 
Device in any order.