ZyXEL p-660hwp Guia Do Utilizador

P-660HWP-Dx User’s Guide

The following describes how to use the command interpreter. You can telnet to access the CLI 
(Command Line Interface) on the P-660HWP-Dx. See the included disk or zyxel.com for 
more detailed information on these commands.

1

Use the following steps to telnet into your P-660HWP-Dx.

1 Connect your computer to the ETHERNET port on the P-660HWP-Dx.
2 Make sure your computer IP address and the P-660HWP-Dx IP address are on the same 

subnet. In Windows, click Start (usually in the bottom left corner), Run and then type 

telnet 192.168.1.1

 (the default P-660HWP-Dx IP address) and click OK.

3 A login screen displays. Enter the default admin password "1234".

• The command keywords are in courier new font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>. 
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means or.

For example,
sys filter netbios config <type> <on|off>
means that you must specify the type of netbios filter and whether to turn it on or off.

A list of valid commands can be found by typing help or? at the command prompt. Always 

type the full command. Type exit to log out of the CLI when finished.