Руководство Пользователя для ZyXEL p-660hwp
P-660HWP-Dx User’s Guide
35
A
P P E N D I X
F
Command Interpreter
The following describes how to use the command interpreter. You can telnet to access the CLI
(Command Line Interface) on the P-660HWP-Dx. See the included disk or zyxel.com for
more detailed information on these commands.
(Command Line Interface) on the P-660HWP-Dx. See the included disk or zyxel.com for
more detailed information on these commands.
1
Use of undocumented commands or misconfiguration can damage the unit and
possibly render it unusable.
possibly render it unusable.
Accessing the CLI
Use the following steps to telnet into your P-660HWP-Dx.
1 Connect your computer to the ETHERNET port on the P-660HWP-Dx.
2 Make sure your computer IP address and the P-660HWP-Dx IP address are on the same
2 Make sure your computer IP address and the P-660HWP-Dx IP address are on the same
subnet. In Windows, click Start (usually in the bottom left corner), Run and then type
telnet 192.168.1.1
(the default P-660HWP-Dx IP address) and click OK.
3 A login screen displays. Enter the default admin password "1234".
Command Syntax
• The command keywords are in courier new font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>.
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means or.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>.
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means or.
For example,
sys filter netbios config <type> <on|off>
means that you must specify the type of netbios filter and whether to turn it on or off.
sys filter netbios config <type> <on|off>
means that you must specify the type of netbios filter and whether to turn it on or off.
Command Usage
A list of valid commands can be found by typing help or? at the command prompt. Always
type the full command. Type exit to log out of the CLI when finished.