Amana 658030-ak 8" dado set Guia Do Utilizador
MACHINE SET-UP
Using the tables elsewhere in this manual, determine
the dado width (kerf) that you would like to cut and
proceed with the following:
the dado width (kerf) that you would like to cut and
proceed with the following:
a.) Unplug and lock out all power to the machine.
b.) Remove table insert, if using a table saw.
c.) Remove lock nut, collar(s), and blade from arbor.
d.) Carefully clean and inspect arbor, threads, lock
b.) Remove table insert, if using a table saw.
c.) Remove lock nut, collar(s), and blade from arbor.
d.) Carefully clean and inspect arbor, threads, lock
nut, flanges, dado components and all safety
devices & guards.
devices & guards.
e.) Determine the proper rotation of the outside
blades (the ‘face’ or flat-side of the teeth should
be facing the front of the machine -
see
illustration #1
). Begin by placing the first collar
on the arbor (if not already attached), then the
first outside blade (the hub should face inward).
Next, add the appropriate chipper(s) and shim(s)
from the table, being sure to stagger the chippers
90 degrees from each other. In addition, the
teeth of the chipper(s) should be placed within
the gullet area of the outside blades (
first outside blade (the hub should face inward).
Next, add the appropriate chipper(s) and shim(s)
from the table, being sure to stagger the chippers
90 degrees from each other. In addition, the
teeth of the chipper(s) should be placed within
the gullet area of the outside blades (
see
illustration #2
). Finally, add the second outside
blade then the collar from the machine and
properly tighten the lock nut according to the
machine manufacturers’ specifications. Double
check that all components are tight and that no
carbide teeth are touching each other.
properly tighten the lock nut according to the
machine manufacturers’ specifications. Double
check that all components are tight and that no
carbide teeth are touching each other.
ILLUSTRATION 1
35˚
15˚
ILLUSTRATION 2
GULLET
AREA
HUB
AREA
AREA
HUBS FACING INWARD
INTERIOR SIDEVIEW OF L/H OUTSIDE BLADE