Vertical ip2007 Guia De Referência
May 2007
Application Note – Configuring a Remote IP2007 Phone
Xcelerator IP 07001
This Application Note addresses the steps required to install a remote IP2007 phone
with Xcelerator IP.
with Xcelerator IP.
Programming Xcelerator IP
To program a remote phone you must be connected to the Xcelerator IP gateway using
Internet Explorer 6.0 or higher. After opening Internet Explorer, enter either the default
IP address of the Xcelerator IP or the user configured IP address into the address bar
and press Return. The default IP address is 192.168.1.1.
Once Xcelerator has been accessed, you will prompted for a username and password;
both the default username and password are admin (lower case for both entries).
Enter programming mode by clicking on the “Advanced Setup” option that appears on
the start up screen.
The main set up screen will appear as depicted in Figure 1 below:
Internet Explorer 6.0 or higher. After opening Internet Explorer, enter either the default
IP address of the Xcelerator IP or the user configured IP address into the address bar
and press Return. The default IP address is 192.168.1.1.
Once Xcelerator has been accessed, you will prompted for a username and password;
both the default username and password are admin (lower case for both entries).
Enter programming mode by clicking on the “Advanced Setup” option that appears on
the start up screen.
The main set up screen will appear as depicted in Figure 1 below:
Figure 1