Vertical ip2007 Guia Do Utilizador

Advanced Settings

5-9

Route
The Routing options are separated into two parts: Static Route and RIP (Routing 

Information Protocol).
Static Route (Add)

-  On the Routing page, click on the ADD button to create a new Static Route.
-  Enter the destination network address, subnet mask, gateway AND/OR available 

WAN interface, then click "Save Settings" to add the entry to the routing table.

-  A maximum of 32 entries may be configured.

-  To activate RIP for a device, select the "Enabled" radio button for Global RIP Mode.
-  To configure an individual interface (br0 or eth0), select the desired RIP version 

(1, 2 or Both) and the mode of operation (Active or Passive), then click the 

"Enabled" checkbox for the desired interface.

-  Click the "Save Settings" button to save the configuration and to start or stop RIP 

based on the Global RIP mode selected.