Viking Range dmos200 Instrução De Instalação

Página de 4
VIKING RANGE CORPORATION
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
PARTS INCLUDED IN THE KIT 
       
5) Template: QTY 1
Minimum Cutout Opening Width 24 3/8" (619.13 mm)
Maximum Cutout Opening Width 24 11/16" (627.06 mm)
14 5/16" (363.475 mm)
M
inimum C
ut
out Op
ening H
eigh
t 16 3/4" (425.5 mm)
M
aximum C
ut
out Op
ening H
eigh
t 17" (431.8 mm)
12 13/16" (325.4 mm)
Distance between holes  25 5/8" (650.75 mm)
Distance between holes   28 5/8" (727.3 mm)
15 29/32" (403.66 mm)
29/32" (23.4 mm)
Center Line
Floor Line of Cutout Opening
BUILT-IN TRIM KIT TEMPLATE
FOR DESIGNER SERIES MICROWAVE OVEN
1.  Align the mounting template center line with the center of 
the cutout and the floor line with the floor of the cutout. 
Tape it into place.
2.  For DMTK271, predrill 4 holes marked  with a 
H
" drill bit.
 
For DMTK301, predrill 4 holes marked   with a 
H
" drill bit.
3.  Remove template from the cabinet
TINSKB110MRR0
1) Frame Assembly
Front Frame 
QTY 1
Back Frame 
QTY 1
2) Bottom Duct Assembly: QTY 1
3) Screw A (1-3/16" length): QTY 2
4) Screw B (1 3/4" length): QTY 4
NOTE:
SIDE FLANGES ON 
DMTK301 ONLY.
INSTALLATION
INSTRUCTIONS
DESIGNER SERIES
MICROWAVE BUILT-IN TRIM KIT
Retain for Future Reference
IMPORTANT - PLEASE READ AND FOLLOW
•  Before beginning, please read these instructions completely and carefully.
•  Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the built-in trim kit.
Remove the turntable from the oven cavity.
•  Because the kit includes metal parts, caution should be used in handling and installation to avoid the possibility of injury.
•  Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
•  Please observe all local and national codes and ordinances.
•  The installer should leave these instructions with the consumer who should retain for local inspector’s use and for future 
reference.
THIS BUILT-IN TRIM KIT IS DESIGNED FOR USE ONLY WITH VIKING MICROWAVE OVENS  SPECIFYING BUILT-IN 
TRIM KIT DMTK271 OR DMTK301 ON THE RATING LABEL ON THE LEFT SIDE WALL OF THE OVEN CAVITY. 
IF YOUR LOWER CONVENTIONAL OVEN IS NOT LISTED IN THE USE AND CARE MANUAL OF THE MICROWAVE 
OVEN, THEN DO NOT INSTALL THE MICROWAVE OVEN ABOVE IT OR IN ANY AREA WHERE HEAT AND STEAM 
ARE GENERATED; FOR EXAMPLE, NEXT TO OR ABOVE A CONVENTIONAL RANGE.