Viking Range dmos200 Instrução De Instalação

C

B

A

4"(10.2 cm

)

4"(10.2 c

m)

6"(15.2 cm

)

SCREW A

BOTTOM
DUCT ASSEMBLY

MAKE FLANGES 
FLUSH

NOTE:

SIDE FLANGES ON 
DMTK301 ONLY.

Outlet should NOT be in the shaded area as indicated

on Illustration 1.

NOTE 1: If the Depth (C) dimension is greater than 1"

(53.3 cm), the outlet location may be in any area on the

rear wall.

NOTE 2: The floor of the opening should be constructed

of plywood strong enough to support the weight of the

oven  and  floor  load  (approximately  100  pounds).  The

floor should be level for proper operation of the oven.

Be sure to check the local building code as it may require

that the opening be enclosed with side, ceiling and rear

partition. The proper functioning of the oven does not

require the enclosure.

1. Align the mounting template center line with the center

of the cutout and the floor line with the floor of the

cutout. Tape it into place.

. For DMTK271, only predrill 4 holes marked “A” with

a  1/16"  drill  bit.  For  DMTK301,  only  predrill  4  holes

marked “B” with a 1/16" drill bit.

3. Remove template from the cabinet

1. Place the Bottom duct in the opening. When the Bottom

Duct Assembly is in the opening correctly, the flanges

will be tightly against the lower edge of the opening.

See Illustration .

. Secure the Bottom Duct Assembly with the two (1-

3

/

16

")

screws A. See Illustration .

Height (A)

Minimum

16

3

/

4

"

(4.5 cm)

Maximum

17"

(43. cm)

Width (B)

Minimum

4

3

/

8

"

(61.9 cm)

Maximum

4

11

/

16

" (6.7 cm)

Depth (C)

Minimum

0"

(50.8 cm)