Videolarm ws6-50nf Guia Do Utilizador

1.  Choose an appropriate corner location. The WS6 can be

     mounted at any height in a corner.

2.  Complete all wire and conduit runs prior to installation of 

     the housing.

Depending on the voltage being used, refer to one of the formulas 
below to select the correct power supply for cameras connected 
in parallel (positive to positive, negative to negative):

(Detailed info on Page 11)
This chart shows the proper current needed for power supplies for 
Warrior Series cameras. Use Class 2 Power only. Input voltage 
must be between 12-28 VDC or 15-28 VAC.

1.  Using the security tool provided, loosen the (3) 10-32 security 

     fasteners and remove the face plate (Figure 1).

4.  Feed the wiring through the conduit knockout.  A clamp 

     connector is included should you desire to use it.  Install 
     the connector so that the nut is on the outside of the housing.  
     Be sure the hole in the wall is large enough to accommodate 
     the nut.  Tighten the nut securely, making sure that the screw 
     heads on  the connector are in an easy to reach position, 
     then feed the wiring through the clamp connector.  

5.  Mount the back box to the wall using appropriate hardware 

     (not provided).
     

NOTE:  If the clamp connector was used, tighten the screws 

                  at this time.  Make sure enough wire is inside    
                  the back box to complete the wiring process.

2.  Place the back box into position and mark the four mounting 

     holes (Figure 2).

3.  If you're using the top conduit knockout (Figure 2) REMOVE 

     THE CAMERA AND BRACKET TO PREVENT DAMAGE.  
     If using one of the side conduit knockouts it's not necessary to 
     remove the camera and bracket; however, use caution.  

Mounting 
Holes

Figure 1

Top conduit knockout behind camera CAMERA MUST BE 
REMOVED BEFORE USING

Mounting Holes

Figure 2