Videolarm ws6-50nf Guia Do Utilizador

- 2 -

8.  To adjust the camera bracket, loosen the two thumb screws 

     (Figure 6). When the desired focus and location are achieved 

     tighten the thumb screws on the brackets in place using needle

     nose pliers. Use Loctite™ or equivalent to secure the screws,

     especially in installations where vibration is a concern.

Figure 3

1.  Connect the output of your Class 2 Power Supply to the terminal 
     connectors on the PC Board inside the housing.  Refer to the 
     Troubleshooting section later in this instruction sheet for more 
     information. 

2.  Connect the incoming video cable to the BNC connector. 

     

NOTE:  For NVT Twisted Pair see Addendum 1.

Terminal Connector

Positive

Negative

NOTE:  The following instructions are for camera bracket setup, 

             camera focusing, and camera set-up. 
             The final steps for installation follow these sections.

Connected to 
the Camera

Connect to 
incoming video 
BNC

Power 
Board

1.  Using the security tool provided, loosen the four security 

     fasteners and remove the housing top.  

NOTE:  The housing 

     top is held to the base by a lanyard. 

2.  Locate the power board on the inside of the housing. The Test
     Monitor Cable plug is located beside the terminal block where
     incoming power is connected (Figure 4).

Figure 4

Power Board

Terminal Connector

Test Monitor Cable plug

3.  Plug the test monitor cable into the power board (Figure 5).

     Attach the BNC connector to your test monitor. 

Test Monitor Cable (NOTE: Your cable may look different)

Figure 5

The plug for the Test 
Monitor Cable is polarity 
protected and can only 
be inserted one way.

Terminal Connector

Video 
Connector

Figure 6

Bracket adjustment thumb screws