Videolarm ws6-50nf Guia Do Utilizador

- 5 -

Your Warrior 6 comes with a replaceable Window Guard™ paint 

shield to protect the front plate window from vandalism.  If vandalism 

occurs (spray paint, scratches, etc.) you need only replace the shield, 

not the entire window.  Additional shields can be ordered.  To replace 

the shield, use the following directions.

1.  Remove the face plate.

2.  On the inside of the face plate, remove the (4) 6-32 nuts 

     holding the window in place (Figure 14).

3.  Remove the damaged paint shield.  

4.  Place a new shield in front of the window.  Reinstall the window, 

     making sure to securely tighten the (4) nuts.  Reinstall the face 

     plate.  

Figure 14

Window

Window Guard™ 
Paint Shield

Reattach the front plate to the back box and tightly fasten the (3)

security screws using the security tool.  

The cameras included in the Warrior series are able to transmit video 
signals to NVT receivers via unshielded twisted pair cable. You must 
purchase the receiver separately. Instructions for connecting the 
receiver end of the unshielded twisted pair cable will be included 
with the NVT receiver. Following are instructions for connecting the 
unshielded twisted pair cable to the PC board inside your Warrior 
housing. See the TROUBLESHOOTING section in the back of these 
instructions if you experience any problems.

UNSHIELDED TWISTED PAIR 

VIDEO WIRING

1. Connect the unshielded twisted pair cable to the positive and 
negative screw terminals on the Warrior PC board (Figure 15).

2.  Connect the other end of the unshielded twisted pair cable to the 
     NVT receiver.  
     

CAUTION:  The unshielded twisted pair video signal is polarity

                        dependent. The positive video terminal on the 
                        Warrior PC board MUST be connected to 
                        the positive terminal on the NVT receiver, and 
                        negative MUST be connected to negative.
3.  When using unshielded twisted pair cable you DO NOT need the 
     BNC connector.  Be sure that there is no video connection other 
     than the unshielded twisted pair cable.  

Video Negative (-)

Video Positive (+)

Figure 15

NOTE:  The customer must purchase the Video Transceiver from 

             NVT.  Part numbers are:
                       • NV-212A (500 ft.)
                       * NV-213A or NV-213A-M (1000 ft.)
                       • NV-652R, NV-862R, or NV-1662R (3000 ft.)

PC Board