Nortel 4134 Guia Do Utilizador
248
Configuration examples
Tunnel destination is not required; packets are dynamically tunneled.
4
To add routes, enter:
ip route 192.168.28.0/24 wan1
ipv6 route 2002::/16 t1
—End—
SR4134 2
Step
Action
1
To configure the IPv4-enabled interface, enter:
interface bundle wan2
link t1 2/0
encapsulation ppp
ip address 192.168.28.10 255.255.255.0
crypto untrusted
exit
2
To configure the IPv6-enabled interface, enter:
interface ethernet 0/2
ipv6 address 2002:c0a8:1c64:1::2/64
exit
3
To configure the tunnel interface, enter:
interface tunnel t1
ipv6 address 2002:c0a8:1c64::1/64
tunnel source 192.168.28.10
tunnel mode ipv6 6to4
exit
Tunnel destination is not required; packets are dynamically tunneled.
4
To add routes, enter:
ip route 192.168.27.0/24 wan1
ipv6 route 2002::/16 t1
—End—
Configuring the firewall for NAT and IPsec tunnels
This example shows how to properly configure the SR4134 firewall to
implement NAT as well as allow IPsec traffic within a Branch Office Tunnel
created between two SR4134s.
implement NAT as well as allow IPsec traffic within a Branch Office Tunnel
created between two SR4134s.
Nortel Secure Router 4134
Security — Configuration and Management
NN47263-600
01.02
Standard
10.0
3 August 2007
Copyright © 2007, Nortel Networks
.