Extreme 3802 Manual Do Equipamento
102
Extreme Networks Consolidated Hardware Guide
Summit Switch Models
NOTE
When configuring the Summit 200-48 switch, all ports specified as mirrored ports and mirroring port, or
ACL ingress ports and egress port, must belong to the same port group. Port group 1 consists of ports
1 through 24 and port 49; port group 2 consists of ports 25 through 48 and port 50.
ACL ingress ports and egress port, must belong to the same port group. Port group 1 consists of ports
1 through 24 and port 49; port group 2 consists of ports 25 through 48 and port 50.
LEDs
The Summit 200-48 switch has the following LEDs:
•
Management
•
Fan
•
Port status
•
Media-Selection (Fiber)
For information about the LEDs and their activity on the Summit 200-48 switch, see “Summit 200-48
Switch LEDs” on page 103 for more details.
Switch LEDs” on page 103 for more details.
Software Requirements
The Summit 200-48 switch requires that you load ExtremeWare version 6.2e.2 or later and
S200BootROM 1.5 or later on your switch.
S200BootROM 1.5 or later on your switch.
Summit 200-48 Switch Rear View
Figure 45 shows the rear view of the Summit 200-48 switch.
Figure 45: Summit 200-48 switch rear view
Power Socket
The Summit 200-48 switch automatically adjusts to the supply voltage. The power supply operates
down to 90 V.
down to 90 V.
Label
The label on the rear of the Summit 200-48 switch displays important information about your switch.
Write down the following information before you install the switch:
Write down the following information before you install the switch:
•
Model number—Shows the model number assigned to this device
•
Part number—Shows the part number assigned to this device
LC48002
Power socket