Citel 3000 Guia Do Utilizador
EXTender 3000 System Administrator’s Guide (Definity)
Remote Module Configuration
Page 49
Data-On-Demand Timeout
As mentioned in the previous section, DOD will disconnect the ISDN data connection after a specified
period of “inactivity”. The DOD timeout specifies that time interval.
period of “inactivity”. The DOD timeout specifies that time interval.
•
The range of this value is 1 to 65,000 seconds.
•
The default value is 60 seconds.
1.
From the Set DOD Mode menu, press NEXT to advance to the Set DOD Timeout menu.
2.
Press OK to access this menu. The current value is displayed.
3.
Enter a new value, if desired.
4.
Press OK to accept the displayed value and return to the Set DOD Timeout menu.
Connection Authentication
The EXTenders allow authentication to be disabled, required only from the Remote Module, required only
from the Office Module, or required from both units. The three receive authentication settings (Receive
Authentication, Receive User Name and Receive Password) specify the authentication information that
the EXTender requires the other unit to send to it. The three send authentication settings (Send Authentica-
tion, Send User Name and Send Password) specify the authentication information that the EXTender will
send to the other unit, if requested.
from the Office Module, or required from both units. The three receive authentication settings (Receive
Authentication, Receive User Name and Receive Password) specify the authentication information that
the EXTender requires the other unit to send to it. The three send authentication settings (Send Authentica-
tion, Send User Name and Send Password) specify the authentication information that the EXTender will
send to the other unit, if requested.
Authentication may be disabled when initially configuring the EXTenders’ ISDN connections and/or for
troubleshooting the ISDN connection. Once the EXTenders are ready for general use, it is recommended that
authentication be enabled on both units.
troubleshooting the ISDN connection. Once the EXTenders are ready for general use, it is recommended that
authentication be enabled on both units.
Setting Receive Authentication
The Remote Receive Authentication specifies the authentication protocol that the Office Module must use to
authenticate with the Remote Module. This means the Office Send Authentication protocol must match the
Remote Receive authentication protocol. If the Office Module does not support the required authentication
protocol, the connection will fail.
authenticate with the Remote Module. This means the Office Send Authentication protocol must match the
Remote Receive authentication protocol. If the Office Module does not support the required authentication
protocol, the connection will fail.
From the Configure PPP menu:
1.
From the Set DOD Mode menu, press NEXT until you advance to the Set Receive Auth menu.
2.
Press OK to access this menu. The telephone will display Recv Auth: xxxx, where xxxx is None, PAP,
or CHAP.
or CHAP.
3.
Press NEXT to scroll through the options.
4.
Press OK to accept the displayed value and return to the Set Receive Auth menu.