LiteOn lvc-9015g Guia Do Utilizador
24
Timer Record
8. [
] [] to select “Date” and press [ENTER] .
Press [
] [] [] [] to make your selection and [ENTER] for
confirmation. To enter the number, use the numbered buttons (0,
1~9).
1~9).
Once:
DATE: MM/DD
Weekly: DATE: SUN/MON/TUE/WED/THU/FRI/SAT
Daily:
Daily:
DATE: - - - - -
(when the “daily” mode is selected, skip to step 8)
If you make a mistake, press
[
]
to re-enter the
correct number.
Note:
When scheduling timer recording on a disc, the unit automatically
sets the recording quality depending on the length of the recording
item. If you wish to set other modes of recording quality, proceed
with step 11.
sets the recording quality depending on the length of the recording
item. If you wish to set other modes of recording quality, proceed
with step 11.
9.Press [
] [] to select “Quality” and then
press [ENTER] to set the mode of recording
quality.
quality.
DVD disc recording mode:
HQ <-> SP <-> EP <->
LP <->SLP
LP <->SLP
Tape recording mode: SP <-> SLP
10 .When finished, press [
][] to select the “
” icon and then press [ENTER] to exit the
“Timer-Record” menu.
“Timer-Record” menu.
If you wish to delete a timer record item, press [
] [] []
[
] to move to the “ ” icon and press [ENTER]. The item
is deleted.
11.Press [POWER] to turn off the unit and acti-
vate the timer record function.
vate the timer record function.
Notes:
1.When the timer record function is active, the “Timer” LED on the
display panel will light up.
display panel will light up.
2. Press [
STOP ] and the recording will be stopped. However,
the recorder may take a few seconds to finish recording on the disc
or tape.
3. Press [DISPLAY] and the timer record information is displayed.
4.Check the status column to see the recording failure analysis:
OK -
or tape.
3. Press [DISPLAY] and the timer record information is displayed.
4.Check the status column to see the recording failure analysis:
OK -
The event is programmed and ready to record.
Error - There is a problem with the event settings. Change the
settings until the Status is “OK.”
Done - The event recorded successfully.
Fail -
settings until the Status is “OK.”
Done - The event recorded successfully.
Fail -
The event failed to record. Move the cursor to the
Status column to view the cause of the error (“No Disc,”
“ Media Defect,” “Disc Full,” and etc. ).
“ Media Defect,” “Disc Full,” and etc. ).