Jiffy j-1 Guia Do Utilizador

1.

Insert cord set (1) into housing and connect black positive wire (2) from
cord set to terminal number 5 on the switch. 

2.

Connect blue wire (4) from the right side of brass heating element (5) to
right side of the L-290 thermostat (6). 

3.

Insert brass heating element unit into housing. Hand tighten the brass nuts
(7) on the water line to the element and to the 90 degree fitting from the
cup. Tighten 2 mounting screws (8) at the base of heating element. Now,
use a 5/8” wrench to securely tighten the brass nuts on the water line to the
element and to the 90 degree fitting from the cup. Heating unit may be
loosened and adjusted for a better fit if necessary.

4.

Place the copper 4 inch grounding strap as shown in drawing. Secure
grounding strap and the green ground wire with the grounding screw by
attaching to the heating element ground location (3).

5.

Connect white wire (9) from the left side of the heater unit to terminal
number 6 on switch. 

6.

Connect yellow wire (10) from the left side of the thermostat to terminal
number 3 on the switch. 

7.

Connect white neutral wire (11) from cord set bundle to orange fusible link
with plastic connector (12). 

8.

Connect other end of orange fusible link to terminal number 2 on the
switch. 

9.

Set steamer upright and place black plastic strain relief (13) approximately
4 1/2” from end of cord set and insert into housing using pliers. 

10. Secure bottom plate with four screws. 

11. To avoid leakage, be sure to tighten hose (or hat nozzle) with wrench before

using steamer.