Revel f50 Guia Do Utilizador

ADJUSTABLE SPIKE FOOTING

When shipped, adjustable spike footing is attached to the bottom
of the cabinet for optimal stability, accommodating installations on
tile, hardwood, and carpeted floors. The F50a is shipped with
spike footing attached as shown on the left side of Figure 5 at the
top of the next page, with the round end protruding from the
cabinet. The protective cap is placed over the round end to protect
tile and hardwood floors.

If the F50a is placed on a carpeted floor, the spike footing should
be adjusted as shown on the right side of Figure 5 (next page),
with the spike end protruding from the cabinet. If needed, follow
the instructions that begin below to adjust the spike footing. 

1. Place the F50a on its side on a soft towel or carpeted floor.

2. Remove the protective cap from the round end of the spike.

Save it for possible future use.

3. Rotate the locking ring counterclockwise to detach it from the

spike. Save it for use in step 6.

4. Rotate the spike counterclockwise to remove it from the cabi-

net.

5. Rotate the spike clockwise into the cabinet, round end first, as

shown on the right side of Figure 5 (next page).

6. Reattach the locking ring, rotating it clockwise to firmly

secure the spike to the cabinet.

7. Repeat steps 2 through 6 for the remaining three spikes. 

8. When all four spikes have been reversed, stand the F50a in the

upright position. If needed, repeat steps 1 and 6 to achieve a
level balance.

9. Repeat these steps to adjust the spike footing on the other F50a.