WatchGuard x1000 Guia Do Utilizador
Appendix A: Troubleshooting Firebox Connectivity
278
WatchGuard Firebox System
2
Power-cycle the Firebox. The light sequence should
look like this:
look like this:
Armed light: Steady
Sys B: Steady (On some Fireboxes, the Sys B light may flicker.)
(Do not be concerned with the lights on the Security Triangle
Display indicating traffic between interfaces.)
3
Take out one end of the serial cable from the Firebox to
break the loop effect.
break the loop effect.
4
On the management station, open a DOS prompt. Ping
the Firebox with a 192.168.253.1.
the Firebox with a 192.168.253.1.
You should get a reply.
5
In Policy Manager, select File => Open =>
Configuration File. Select the configuration file you
want to load onto the Firebox and load it into Policy
Manager.
Configuration File. Select the configuration file you
want to load onto the Firebox and load it into Policy
Manager.
6
In Policy Manager, select File => Save => To Firebox.
When you are prompted for an IP address, use
192.168.253.1 with wg as the passphrase.
When you are prompted for an IP address, use
192.168.253.1 with wg as the passphrase.
7
When the Firebox Flash Disk dialog box appears,
select the button marked Save Configuration File and
New Flash Image.
select the button marked Save Configuration File and
New Flash Image.
8
After the file has been restored on the Firebox, you will
have to reassign the IP address of your management
station such that it is on the same network as the
trusted interface from the configuration file that you
just used. This will enable you to reconnect to the
Firebox with the trusted IP address that is listed in the
configuration file and your status passphrase.
have to reassign the IP address of your management
station such that it is on the same network as the
trusted interface from the configuration file that you
just used. This will enable you to reconnect to the
Firebox with the trusted IP address that is listed in the
configuration file and your status passphrase.