3com 5500-ei pwr Instrução De Instalação

 

1-6 

In this way, the forwarding table entries of each device in the fabric can be consistent. Even if the master 

fails, other devices can use the forwarding table synchronized from the master to perform layer 3 

forwarding, thus ensuring the accuracy of forwarding path. After re-electing the master, the fabric will 

restart routing update. 

As a new link aggregation mode, DLA can improve fault tolerance and redundancy backup of user 

networks. 

Link aggregation enables you to configure ports on the same device as an aggregation port group, 

avoiding network interruptions resulted from single port failure. Based on link aggregation, DLA 

provides a more reliable solution, with which you can select ports on different devices to form an 

aggregation port group. In this way, single port failure can be avoided and network reliability can be 

greatly improved, because the fabric can communicate with the destination network through ports on 

other devices in case a single device fails. 

Complete the following tasks to configure XRN fabric: 

Required 

Specifying the VLAN Used to Form an XRN Fabric 

Optional 

Setting a Unit ID for a Switch 

Optional 

Optional 

Optional 

Optional 

Optional 

 

You can specify the fabric port of a switch in either system view or Ethernet interface view. 

Follow these steps to specify a fabric port: 

Enter system view 

— 

Specify the fabric port of a 
switch 

fabric-port interface-type 
interface-number enable 

Required 

Not specified by default 

 

Follow these steps to specify a fabric port: