3com S7906E Guia De Referência

 

1-8 

2: System level 

group-id: Port mirroring group number, in the range of 1 to 4. 

Use the monitor-port command to configure a port as the destination mirroring port of a port mirroring 

group.  

Use the undo monitor-port command to remove the destination mirroring port from a port mirroring 

group. 

If you do not specify the mirroring-group group-id keyword-argument combination, the monitor-port 

command adds the current port to port mirroring group 1. 

Note that:  

z 

If you do not specify the mirroring-group group-id keyword-argument combination, these two 

commands apply to port mirroring group 1. 

z 

A remote source mirroring group cannot contain destination mirroring ports. 

z 

Member ports of existing port mirroring groups cannot be destination ports.  

z 

The remote destination mirroring port can be an access, trunk, or hybrid port. It must be assigned 

to the remote mirroring VLAN.  

z 

Before adding the destination port for a port mirroring group, make sure the port mirroring group 

exists. 

z 

Do not enable STP, RSTP, or MSTP on the destination port. Otherwise, the mirroring function may 

be affected. 

z 

Do not use the destination mirroring port for any purpose other than port mirroring. 

# Add port Ethernet 2/0/1 to port mirroring group 1 (a local port mirroring group) as the destination port. 

<Sysname> system-view 

[Sysname] mirroring-group 1 local 

[Sysname] interface Ethernet 2/0/1 

[Sysname-Ethernet2/0/1] monitor-port 

uni uni-number mirroring-port { both | inbound | outbound } 

undo uni uni-number mirroring-port 

ONU port view  

2: System level