Xerox N2825 Manual Do Utilizador
Set An IP Address
2-10 ❖
DocuPrint Technical Information Guide
5
Type Telnet x.x.x.x[Enter].
Make sure that telnet is enabled on the External
Ethernet Adapter by examining the position of the
DIP switches which are located on the rear panel.
D1 should be in the up position and D2 should be
in the down position. If you change the position of
the switches, make sure you cycle the power off
and on before proceeding.
Ethernet Adapter by examining the position of the
DIP switches which are located on the rear panel.
D1 should be in the up position and D2 should be
in the down position. If you change the position of
the switches, make sure you cycle the power off
and on before proceeding.
6
When the telnet window appears, type ! [Enter]
(exclamation point) and then yes [Enter] to enter
monitor mode.
(exclamation point) and then yes [Enter] to enter
monitor mode.
7
Type I [Enter] to enter the IP address. Enter the desired IP
address.
address.
8
Reboot the network interface by typing R[Enter].
When you reboot the network interface, you will
lose your telnet connection. Close the telnet
session window and open a new connection after
the network interface has rebooted.
lose your telnet connection. Close the telnet
session window and open a new connection after
the network interface has rebooted.
When the Xerox CentreDirect External Print Server (External
Ethernet Adapter) acquires an IP Address, the SYS LED blinks
once per second. If the IP Address is not set the SYSLED blinks
5 times per second.
Ethernet Adapter) acquires an IP Address, the SYS LED blinks
once per second. If the IP Address is not set the SYSLED blinks
5 times per second.