Xerox N2825 Manual Do Utilizador
Set An IP Address
2-12 ❖
DocuPrint Technical Information Guide
5
Open a telnet session by typing telnet name[Enter].
Make sure that telnet is enabled on the
CentreDirect External Print Server (External
Ethernet Adapter) by examining the position of
the DIP switches which are located on the rear
panel. D1 should be in the up position and D2
should be in the down position. If you change the
position of the switches, make sure you cycle the
power off and on before proceeding.
CentreDirect External Print Server (External
Ethernet Adapter) by examining the position of
the DIP switches which are located on the rear
panel. D1 should be in the up position and D2
should be in the down position. If you change the
position of the switches, make sure you cycle the
power off and on before proceeding.
6
When the telnet window appears, type ! [Enter]
(exclamation point) and then yes [Enter] to enter
monitor mode.
(exclamation point) and then yes [Enter] to enter
monitor mode.
7
Type I[Enter] to enter the IP address. Enter the desired IP
address.
address.
8
Reboot the network interface by typing R [Enter].
When you reboot the network interface, you will
lose your telnet connection. Close the telnet
session window and open a new connection after
the network interface has rebooted.
lose your telnet connection. Close the telnet
session window and open a new connection after
the network interface has rebooted.
When the Xerox CentreDirect External Print Server (External
Ethernet Adapter) acquires an IP Address, the SYS LED blinks
once per second. If the IP Address is not set the SYSLED blinks
5 times per second.
Ethernet Adapter) acquires an IP Address, the SYS LED blinks
once per second. If the IP Address is not set the SYSLED blinks
5 times per second.