ONKYO htp-640 Manual De Instruções

 

4

 

A

 

These push terminals 
are for connecting the 
speaker to your AV 
Receiver, amp, or 
other receiver with the 
supplied speaker 
cables. The supplied 
speaker cables are 
color-coded for easy 
identification. Simply 
connect each cable to 
the same-colored posi-
tive speaker terminal.

 

B

 

These threaded inserts can be used to attach the 
speaker to a speaker mount or bracket.

 

Use commercially available 1/4" screws to attach 
the speaker to a speaker mount or bracket.

 

C

 

These keyhole slots can be used to wall-mount the 
speaker.

Use the center speaker base to mount the center speaker 
horizontally. If you place the speaker and its base on top 
of a TV or an entertainment center, adjust the angle of 
the speaker so that it faces toward the listening position. 
The center speaker should be installed on the base 
securely. If the speaker is loose, try adjusting the posi-
tion so that it sits securely on the base.
The cradle surface of the base features two stoppers to 
prevent the speaker from moving. Therefore, you can 
tilt the speaker toward the front by up to 15 degrees.

 

■

 

We recommend using the 
supplied rubber spacers to 
achieve the best possible 
sound from your speak-
ers. The rubber spacers 
prevent the speakers from 
moving, providing a more 
stable setup.

The speakers can easily be wall mounted by using the 
keyhole slots. To prevent the speaker from vibrating 
against the wall, attach four of the supplied rubber spac-
ers to the rear of each speaker.

 

■

 

To mount the speakers vertically, use the one keyhole 
slot shown to hang each speaker on the screw that is 
securely screwed into the wall.

 

■

 

To mount the speakers horizontally, use the two keyhole 
slots shown to hang each speaker on two screws that are 
securely screwed into the wall.

The plaque of each speaker rotates so that you can posi-
tion the speakers upside down.

 

A mounting screw’s ability to support a speaker 
depends on how well it’s anchored to the wall. If you 
have hollow walls, screw each mounting screw into a 
stud. If there are no studs, or the walls are solid, use 
suitable wall anchors.
Use screws with a head diameter of 3/8" or less and a 
shank diameter of 1/8" or less. With hollow walls, use a 
cable/pipe detector to check for any power cables or 
water pipes before making any holes.
Leave a gap of 1/4"–5/16" 
between the wall and the 
base of the screw head, as 
shown.

(We recommend that you 
consult a home installation 
professional.)

3

1

2

SKC-640C

Base for horizontal 
mounting

Stoppers

Rubber spacer

Bottom of 
the bass

Rubber spacer

Keyhole slot for 
wall mounting

Keyhole slot for wall 
mounting

Rubber spacers

Wall

1/4"–5/16"

HTP-640_En.fm 4 ページ ２００６年６月２２日 木曜日 午前１１時９分