ONKYO htp-640 Manual De Instruções
5
A
STANDBY/ON indicator
Red:
Subwoofer in standby mode
Green: Subwoofer on
With the Auto Standby function, the SKW-540
automatically turns on when an input signal is
detected in Standby mode. When there’s no input
signal for a while, the SKW-540 automatically
enters Standby mode.
automatically turns on when an input signal is
detected in Standby mode. When there’s no input
signal for a while, the SKW-540 automatically
enters Standby mode.
B
OUTPUT LEVEL control
This control is used to adjust the volume of the sub-
woofer.
woofer.
C
LINE INPUT
This RCA input should be connected to the sub-
woofer preout on your AV receiver, amp, or other
receiver with supplied RCA cable.
woofer preout on your AV receiver, amp, or other
receiver with supplied RCA cable.
Note:
The Auto Standby function turns the subwoofer on
when the input signal exceeds a certain level. If the
Auto Standby function does not work reliably, try
slightly increasing or decreasing the subwoofer out-
put level on your receiver or amp.
when the input signal exceeds a certain level. If the
Auto Standby function does not work reliably, try
slightly increasing or decreasing the subwoofer out-
put level on your receiver or amp.
Connecting the Speakers
Read the following before connecting your speakers:
• Turn off your amp before making any connections.
• Disconnect the power cord from the wall outlet before
making any connections.
• Pay close attention to speaker wiring polarity. Connect
positive (+) terminals to only positive (+) terminals,
and negative (–) terminals to only negative (–) termi-
nals. If the speakers are wired incorrectly, the sound
will be out of phase and will sound unnatural.
and negative (–) terminals to only negative (–) termi-
nals. If the speakers are wired incorrectly, the sound
will be out of phase and will sound unnatural.
• Be careful not to short the posi-
tive and negative wires. Doing so
may damage your amp.
may damage your amp.
Use the cables to connect each speaker’s input
terminals to the corresponding speaker output
terminals on your receiver.
terminals to the corresponding speaker output
terminals on your receiver.
To make a connection, while pressing
the terminal lever, insert the wire into
the hole, and then release the lever.
Make sure that the terminals are grip-
ping the bare wires, not the insulation.
the terminal lever, insert the wire into
the hole, and then release the lever.
Make sure that the terminals are grip-
ping the bare wires, not the insulation.
Using the supplied RCA cable, connect the sub-
woofer’s LINE INPUT to your receiver’s SUB-
WOOFER PREOUT.
woofer’s LINE INPUT to your receiver’s SUB-
WOOFER PREOUT.
Subwoofer (SKW-540)
1
2
3
■ Rear
To AC outlet
■ Front
Connecting the Speaker Cables
Connecting the Subwoofer
PRE OUT
SUB
WOOFER
LINE INPUT
Subwoofer
Center
speaker
speaker
Front left
speaker
speaker
Front right
speaker
speaker
Surround
right
speaker
right
speaker
Surround
left
speaker
left
speaker
Red
White
Green
Gray
Blue
HTP-640_En.fm 5 ページ ２００６年６月２２日 木曜日 午前１１時９分