ONKYO TX-SR603X Manual De Instruções
45
First Time Setup
—Continued
Crossover
Note:
If the crossover frequency is set to a low value, and the
program material doesn’t contain any sounds below that
frequency, the subwoofer will not output much sound.
program material doesn’t contain any sounds below that
frequency, the subwoofer will not output much sound.
6
Use the Up and Down [
]/[
]
buttons to select “d. Surround,”
and then use the Left and Right
[
and then use the Left and Right
[
]/[
] buttons to select:
Small:
Select if the surround left and
right speakers are small.
right speakers are small.
Large:
Select if the surround left and
right speakers are large.
right speakers are large.
None:
Select if no surround left and
right speakers are connected.
right speakers are connected.
Note:
If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
Small, the Large option cannot be
selected.
7
Use the Up and Down [
]/[
]
buttons to select “e. SurrBack,”
and then use the Left and Right
[
and then use the Left and Right
[
]/[
] buttons to select:
Small:
Select if the surround back
left and right speakers are
small.
small.
Large:
Select if the surround back
speakers are large.
None:
Select if no surround back
speakers are connected.
Notes:
• If the Surround setting in step 6 is set
to None, this setting cannot be
selected.
selected.
• If the Surround setting in step 6 is set
to Small, this setting cannot be set to
Large.
Large.
8
Use the Up and Down [
]/[
]
buttons to select “f. SurrBack
ch,” and then use the Left and
Right [
ch,” and then use the Left and
Right [
]/[
] buttons to select:
1ch:
Select if one surround back
speaker is connected.
2ch:
Select if two (left and right)
surround back speakers are
connected.
connected.
Note:
If the Surround Back Setting in step 7 is
set to None, this setting cannot be
selected.
set to None, this setting cannot be
selected.
Continue with step 9 in the right col-
umn.
umn.
ENTER
ENTER
ENTER
9
Use the Up and Down [
]/[
]
buttons to select “g. Crossover,”
and then use the Left and Right
[
and then use the Left and Right
[
]/[
] buttons to select a
crossover frequency.
Choose a crossover frequency suitable
for your setup. If you’re using a sub-
woofer, choose a crossover frequency
based on the diameter of your front
speakers. If you’re not using a sub-
woofer, use the diameter of any speaker
that you specified as Small.
for your setup. If you’re using a sub-
woofer, choose a crossover frequency
based on the diameter of your front
speakers. If you’re not using a sub-
woofer, use the diameter of any speaker
that you specified as Small.
Continue with step 10 on page 46.
ENTER
Speaker cone
diameter
Crossover
frequency
Over 8 in.
(20 cm)
60 Hz
6-1/2 to 8 in.
(16–20 cm)
80 Hz
5-1/4 to 6-1/2 in.
(13–16 cm)
100 Hz
3-1/2 to 5-1/4 in.
(9–13 cm)
120 Hz
Under 3-1/2 in.
(9 cm)
150 Hz
TXSR603X.book 45 ページ 2005年8月3日 水曜日 午後2時2分