ONKYO TX-SA806 Guia Do Utilizador

47

If the impedance of any speaker is 4 ohms or more but 
less than 6, set the minimum speaker impedance to 4 
ohms.
If you’ve connected your front speakers to the FRONT 
L/R and SURR BACK L/R terminal posts for bi-amping, 
you must change the “Speakers Type” setting. For 
hookup information, see “Bi-amping the Front Speak-
ers” on page 19.

Notes:
• When bi-amping is used, the AV receiver/AV ampli-

fier is able to drive up to 5.1 speakers in the main 
room.

• Before you change these settings, turn down the vol-

ume.

Note:
This procedure can also be performed on the AV 
receiver/AV amplifier by using its [SETUP] button, 
arrow buttons, and [ENTER] button.

Press the [RECEIVER] button, 
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make 
sure the appropriate external input is 
selected on your TV.

q]/[w] but-

tons to select “2. Speaker 
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.

q]/[w] but-

tons to select “1. Speaker Set-
tings”, and then press [ENTER].
The “Speaker Settings” menu appears.

If you change these settings, you must run the auto-
matic speaker setup again (see page 51).

q]/[w] but-

e]/[r] buttons to select:

Normal: Select this if you’ve con-

nected your front speakers 
normally.

Bi-Amp:Select this if you’ve con-

nected your front speakers for 
bi-amped operation.

Notes:
• Powered Zone2 cannot be used if 

“Speakers Type” is set to “Bi-Amp”.

• The analog multichannel input can-

not be used if “Speakers Type” is set 
to “Bi-Amp”.

q]/[w] but-

e]/[r] buttons to select:

4ohms: Select if the impedance of any 

speaker is 4 ohms or more but 
less than 6.

6ohms: Select if the impedances of all 

speakers are between 6 and 
16 ohms.

Press the [SETUP] button.
The setup menu closes.

TX-SR806_En.book  Page 47  Monday, August 4, 2008  10:25 AM