Elmo EDR-X04 Manual Do Utilizador

15

1.  Type of Connection: LAN, PSTN, ISDN, Leased Circuit (router) can be used for remote connection. ISDN or 

Leased circuit with router connection is possible, and ISDN or PSTN can be used to connect to a DVR without 
a router directly. If you don’t use a remote connection click on ‘No Connection’. 

a)  Motion for Emergency Message: When motion is detected at the selected camera(s) an 

emergency message is sent to the programmed phone number(s) or IP address(es). Emergency 
monitor must be running at indicated IP address(es). 

b)  Sensor for Emergency: If the sensor detects any signal it will send an alarm to the center with 

the captured image during the designated time. (You can assign the external sensor numbers.) 

c)  Emergency Phone Numbers: When you use PSTN for connection you can assign up to 2 phone 

numbers for an emergency connection. If the first attempt to connect fails, the second number will 
be dialed. 

d)  Transfer Time: When connection has been made, you can assign the time in seconds to transfer 

the image to the Center PC. (If any other signal is detected during the transfer, the DVR will 
transmit the image again.) 

e)  Emergency IP Address: Enter the IP address in ‘Emergency IP Address’, to connect to a 

designated site. (Under LAN, Leased Circuit connection.) 

3.  Live Video Stream Bandwidth: This allows user to control the bandwidth of the data transfer over the 

network. 

4.  Frequency of call-out (0:00-24:00): In the 24-hr period users can set the number of emergency call-outs.