PowerDsine pd-6506 Guia Do Utilizador

 

 

You must read the following safety information before carrying out any 
installation, removal or any maintenance procedure on the Power over 
Ethernet Midspan. Warnings contain directions that must be followed for 
personal and product safety. Follow all directions carefully. 

 

WARNINGS   
 

•  Read the Installation Instructions in Section 3 before 

connecting the Power over Ethernet Midspan to its power 
source. 

•  The Midspan must use a grounded power cord, as 

defined in paragraph 1.2. 

•  This product relies on the building installation for short-

circuit (overcurrent) protection. Ensure that a fuse or 
circuit breaker no larger than 15 A for 120 VAC, (U.S.) 10 
A for 230 VAC (international) is used. 

•  Do not work on the system, connect or disconnect cables 

during periods of lightning activity. 

•  A voltage mismatch can cause equipment damage and 

may pose a fire hazard. If the voltage indicated on the 
label is different from the power outlet voltage, do not 
connect the Power over Ethernet Midspan to this outlet. 

•  For shelf-mounted equipment, be certain that the surface 

is stable and strong enough to support the equipment. Do 
not stack more than four the Power over Ethernet 
Midspans. 

•  Ultimate disposal of this product should be handled 

according to all local laws and regulations.  

•  The Power over Ethernet Midspan "Data" and "Data + 

Power" ports are shielded RJ-45 data sockets. They 
cannot be used as Plain Old Telephone Service (POTS) 
telephone sockets. Only RJ-45 data connectors may be 
connected to these sockets. 

•  Associated ethernet wiring shall be limited to

 

inside of the 

building. 

a