Avaya 6211 Cartão De Referência Rápida

Note:  For wall installation, do NOT unbundle the line cord 
packaged with the telephone; that is, leave the line cord in its 
coiled position.

You must reverse the handset tab (which holds the 
handset when you hang up). See Figure 4.

■

Hold down the switchhook and slide the handset tab up 
and out of its slot. 

■

Turn the tab so that the curved end is facing up.

■

Insert the tab back into its slot.

Turn the telephone upside down so that you can see the 
bottom of the telephone. 

Remove the mounting base by sliding the base to the left 
until it is free of the telephone. See Figure 4.

Turn the base so the larger end is down.

Plug one end of the line cord into the line jack on the 
bottom of the telephone. (Keep the cord bundle in the 
cavity on the lower housing.) Leave the other end of the 
cord unattached for later use.
Note:  You may prefer to use an 8-inch line cord rather 
than the 14-foot cord provided with the telephone. If you 
use the 14-foot cord, you will need to place it into the 
back of the telephone in its original coiled position.

After you have attached the stand to the telephone, use 
the screw provided to tighten the stand onto the back of 
the telephone set.

a. Handset

b. Press to release

d. Replace handset

c. Reposition

retainer

in place

and then remove

handset retainer

handset

retainer

down

retainer

(down

(up

position)

position)

230709i3.fm  Page 6  Thursday, February 27, 2003  2:28 PM