KYOCERA 2345 Guia Do Utilizador

Página de 64
Resetting the phone
If the screen seems frozen and the keypad does not 
respond to keypresses, reset the phone by 
completing the following steps:
1.
Remove the battery door.
2.
Remove and replace the battery.
If the problem persists, return the phone to the 
dealer for service. 
Qualified service
If you are experiencing problems with your phone, 
see “Getting Help” on page 50. If you have 
additional questions, contact your service provider 
for technical support. If the problem persists, return 
the phone with all accessories and packaging to the 
dealer for qualified service.
Accessories
Use only Kyocera-approved accessories with 
Kyocera phones. Use of any unauthorized 
accessories may be dangerous and will invalidate 
the phone warranty if said accessories cause 
damage or a defect to the phone. 
To shop online for a Hands-free Car Kit and other 
phone accessories, visit 
www.kyocera-wireless.com/store
To order by phone, call (800) 349-4188 (U.S.A. only) 
or (858) 882-1410.
Radio Frequency (RF) energy
Your telephone is a radio transmitter and receiver. 
When it is on, it receives and sends out RF energy. 
Your service provider’s network controls the power 
of the RF signal. This power level can range from 
0.006 to 0.6 watts.
In August 1996, the U.S. Federal Communications 
Commission (FCC) adopted RF exposure guidelines 
with safety levels for hand-held wireless phones. 
These guidelines are consistent with the safety 
standards previously set by both U.S. and 
international standards bodies in the following 
reports:
• ANSI C95.1 (American National Standards 
Institute, 1992)
• NCRP Report 86 (National Council on Radiation 
Protection and Measurements, 1986)
• ICNIRP (International Commission on 
Non-Ionizing Radiation Protection, 1996)
Your phone complies with the standards set by these 
reports and the FCC guidelines.
E911 Mandates
Where service is available, this handset complies 
with the Phase I and Phase II E911 Mandates issued 
by the FCC.
Battery and Charger Specifications
  093 453 037
Kyocera Wireless Corp.
10300 Campus Point Drive 
San Diego, CA 92121 U.S.A.
Visit us at www.kyocera-wireless.com
To purchase accessories, visit 
www.kyocera-wireless.com/store
Charger
Input
Output
CV90-B1523-1
100-240VAC / 50/60Hz
4.4V 1A
CV90-60858-1
100-240VAC / 50/60Hz 
4.5V 1.5A
CV90-B1501-1
100-240VAC / 50/60Hz 
4.4V 1A
CV90-61016-1
100-240VAC / 50/60Hz 
4.5V 1.5A
CV90-60859-1
120VAC / 60Hz
5.2V 400mA
Standard Battery: 3.6V / 975mAh