Sony SRS-DB500 Manual Do Utilizador

• Make sure all the connections have been 

correctly made.

• Make sure the satellite speaker and the 

connected device have been turned up 
properly.

• Connect only the supplied speakers.
• Check if the headphones are connected. 

If there are, disconnect them.

If the system still does not operate 
properly after performing the above 
measures or other troubles not described 
above occur, reset the system as follows:

Unplug the power cord.

Wait for 5 minutes before plug the 
power cord back in.

Press "/1 to turn on the system.

Press INPUT and "/1 at the same 
time and hold for 3 seconds.

The system is reset to the factory settings.  
You need to readjust all the settings you 
made, such as volume, bass level, treble 
level and input source.

• The nameplate indicating operating 

voltage, power consumption, etc., is 
located on the rear exterior.

• Before operating the system, be sure 

that the operating voltage of the system 
is identical with that of your local power 
supply.

• Unplug the system from the wall outlet 

if it is not to be used for an extended 
period of time. To disconnect the cord, 
pull the cord by grasping the plug. 
Never pull the cord itself.

• Should any liquid or solid object fall 

into the system, unplug the system’s 
power cord and have the system 
checked by qualified personnel before 
operating it any further.

• For efficient heat dissipation, ensure 

there is sufficient space to the rear of the 
subwoofer. Also, avoid placing objects 
on the unit.

• Do not insert your hand or any objects 

into the hole of the subwoofer and 
satellite speaker.

If main plug of the system is disconnected 
from the AC outlet while the system is on 
standby mode, the "/1 indicator will 
continue to lights up for about 2 minutes, 
depends on time taken for the internal 
high efficiency audio grade switching 
mode power supply to be fully 
discharged.

• Do not drive the speaker system with a 

continuous wattage exceeding the 
maximum input power of the system.

• Before connecting, turn off the speaker 

system, the PC and audio device to 
avoid damaging the speaker system.

• The volume level should not be turned 

up to the point of distortion.

l